Perma USA | Lubricators | Classic



Electrochemical CLASSIC FUTURA FROST Electromechanical STAR VARIO STAR CONTROL PRO PRO MP-6 ECOSY	perma CLASSIC Installation •We recommend activating the unit prior to installing it. Do not expect immediate discharge; operating pressure takes from 1 to 12 days to develop, depending on the PERMA month type • Take the plastic activator and begin to hand tighten into the opening bottom of the PERMA. • When the activator becomes hand tight, take a screw driver and insert it through the top ring of the activator (fig.1). PERMA Classic activators are recognized by the Black O-ring seal and Futura activators by their Pink O-ring seal. Continue to tighten until the O-ring breaks off (fig. 2). DO NOT break ring off by hand. This could jeopardize the activation of the PERMA. To insure the activation pellet has fallen from the activator into the bladder that starts the chemical dispensing reaction, simply shake the PERMA to hear the pellet rattle inside. •• Enter installation & replacement dates on the label. •• Prior to installation, ALWAYS pre-lubricate the bearing/lubrication point using a hand grease gun filled with the same or compatible grease as the PERMA to ensure it is accepting grease freely. • •Remove the grease fitting. • •Remove the black outlet plug from the PERMA canister. • •Typically most bearing lubrication ports are 1/8” or 1/4”. The PERMA thread is 1/4” MNPT. If the grease inlet is 1/8”, you will need a 1/4” F x 1/8” M adapter (part # B100; fig. 3). If your inlet is 1/4”, you can mount direct. Either way, screw the PERMA into the fitting or bearing hand tight only. • •Bearing requiring greater amounts of grease can be served by mounting several PERMAS in series using standard PERMA Accessory Parts (fig.4). • •Grease filled PERMAS may be mounted in any direction (fig. 5), even under water. • •All Oil filled PERMAS require a check valve at the point of lubrication (part# A810). Remote Installations & Max. Remote Distance w/ NLGI #2 Grease @ 77 F • •PERMAS may be remote mounted by means of pipe or tubing/hose. This allows for continuous lubrication of hard to reach spots, such as points located inside of machinery guards. Always use 1/4” pipe or 3/8” tubing/hose (150 PSI minimum burst pressure rating). Make sure pipe or tubing is pre-filled with the same or compatible lubricant. 1-month (6 feet), 3-month (4 feet), 6-month (2 feet), 12-month (1 foot) • •Lower NLGI grades and oil may be remote further distances. Call for assistance. Home \| Lubricators \| Accessories \| Applications \| Services \| Members Copyright © 1997-2006 H-T-L perma USA.